Do you offer emergency electrician service in Johnston, IA?

Yes, an emergency electrician in Johnston, IA can be dispatched for burning smells, a buzzing or hot panel, sparking outlets, or half the house losing power. Turn off the affected breaker if it's safe to reach, then call. Don't wait these out. The NFPA estimates electrical distribution and lighting equipment caused an average of 32,620 U.S. home fires a year from 2015 to 2019, with December among the peak months.

How do I know if my Johnston home needs a panel upgrade?

Look at the main breaker first. If it reads 100 amps and you're planning an EV charger, heat pump, or finished basement, you'll likely need 200-amp service. Other red flags include no open breaker slots, double-tapped breakers, a panel cover that feels warm, or an older Federal Pacific Stab-Lok or Zinsco panel. We see those brands in Johnston homes built before the mid-1980s, and we recommend replacing them outright.

What causes a circuit breaker to keep tripping?

Breakers trip when they detect an overload, a short circuit, or a ground fault. If one keeps tripping, the usual suspects are too many appliances on a single circuit, a breaker that's wearing out, or a wiring fault further down the line. Our electricians trace it with diagnostic tools, then tell you whether the fix is a circuit repair, a dedicated circuit, or a panel upgrade. Resetting it over and over isn't a fix. It's a warning you're choosing to ignore.

Do you install EV chargers in Johnston and nearby cities?

We install Level 2 EV chargers for homeowners throughout the Des Moines metro, including Pleasant Hill, Norwalk, and Mitchellville. The job starts with a check of your panel's available capacity. From there, we pull the required permit, run a dedicated 240-volt circuit, and mount the charger where you park. If your panel needs an upgrade to support the added load, we handle that as part of the same project.

Can you add a ceiling fan to a room that has no existing light fixture?

It means running a new cable from a wall switch to the ceiling, installing a fan-rated box, and patching only small access holes. In most ranch homes in Johnston, attic access over the bedrooms makes this a half-day job. Two-story homes with finished space above take longer, since we have to fish the wire between floors. Either way, you'll know the price before we cut anything.

Can you run power to a shed or outbuilding?

We do, either underground or overhead, to detached garages, workshops, and sheds. Buried runs follow NEC Table 300.5, which calls for 24 inches of cover on direct-burial cable and 18 inches for PVC conduit in most yards. We size the circuit for the equipment you'll actually run, whether that's a few lights, power tools, or a 240-volt outlet for a welder or table saw. Customers in Polk City and Bondurant often call us when finishing a backyard workshop.

Do you offer electrical inspections for homes in the Des Moines area?

Our electrical safety inspection covers your panel, wiring, outlets, grounding, and load distribution. We look for outdated wiring, overloaded circuits, missing GFCI and AFCI protection, and code violations that could lead to fire or shock. You get a written report listing every issue and the repair we recommend. Homebuyers in Johnston, Altoona, and Carlisle book this before closing so they know what they're buying.

Do you install generators in the Des Moines area?

Generator work is one of our busiest services. We size, install, and maintain Generac standby generators for homes throughout the metro. Installation includes connecting to your natural gas or propane supply, installing the automatic transfer switch, and testing the full system under load. Annual maintenance visits check the battery, the transfer switch, and a load test so the unit is ready the next time the grid goes down.

What LED lighting services do you offer?

We convert existing fixtures to LED throughout the house, including recessed lighting, under-cabinet lighting, and exterior fixtures. LED retrofits use less energy and give off far less heat than incandescent and halogen bulbs. We also design new recessed lighting layouts for kitchens, living rooms, and home offices. Homeowners in Altoona and Newton often ask for whole-home LED conversions while they're updating older wiring.

Are your electricians licensed in Iowa?

Every electrician on our team holds a state license issued through the Iowa Department of Inspections, Appeals, and Licensing (DIAL). Iowa requires licensed electricians to complete 18 hours of continuing education every three years, six of them on the National Electrical Code. That matters when you're comparing quotes for a licensed electrician in the Des Moines metro. You can verify any contractor's license on the DIAL website before you sign anything.

How do I book an electrician in Johnston with Mr. Electric of Central Iowa?

Call at any hour, or schedule an appointment online . We'll confirm an arrival window, and your electrician will give you a flat-rate quote before any work begins. We serve Johnston, Des Moines, Urbandale, Ankeny, Grimes, West Des Moines, and communities across the metro, and every job is backed by the Neighborly Done Right Promise®.

Licensed Electrician Johnston, IA

A breaker that won't reset. A bedroom with no power. A ceiling fan that wobbles every time it hits high speed. That's when you need an electrician. Johnston, IA residents want someone who's already fixed their exact problem in a house a lot like theirs. Mr. Electric of Central Iowa has served the metro since 2001; our electricians average 15 years in the trade, and local residents voted us the best Des Moines electrician in 2024 and 2025. You'll see a flat-rate price before any work starts, and every job is backed by the Neighborly Done Right Promise®. Call, and we'll get you on the schedule.

Residential
Commercial

Book Online

First Name*

Last Name*

Email*

Phone Number*

Street Address*

ZIP/Postal Code*

Yes! You can text me service reminders and other messages.

By checking this box, I agree to opt in to receive automated informational and promotional SMS and/or MMS messages from Mr. Electric, a Neighborly company, and its franchisees to the provided mobile number(s). Messages & data rates may apply. Message frequency varies. View Terms and Privacy Policy. Reply STOP to opt out of future messages. Reply HELP for help.

By entering your email address, you agree to receive emails about services, updates or promotions, and you agree to the Terms and Privacy Policy. You may unsubscribe at any time.

Johnston, IA Electrical Services for Every Room, Panel, and Outbuilding

Older Johnston homes often need updated wiring, more outlets, or additional panel capacity. Newer homes bring different requests, including EV chargers and backup generators. Mr. Electric of Central Iowa handles both. Our licensed electricians serve Johnston, Urbandale, Grimes, and Ankeny, following Iowa's adopted electrical code.

Outlets, Switches, and Circuits That Keep Tripping

A room with no power usually comes down to a tripped GFCI upstream, a loose backstabbed outlet, or a breaker that's worn out. We find which one before replacing anything. Repeated trips are a different story. Late fall is when we see them most, right after space heaters come out of storage. The fix is usually a circuit breaker replacement or a new dedicated circuit for whatever's overloading the line.

Electrical Panel Repair and Upgrades

Plenty of older Johnston homes still run 100-amp service. Add a heat pump, an induction range, and an electric vehicle, and that panel runs out of room fast. We repair failing panels and handle electrical panel upgrades to 200-amp service, including the permit and the utility disconnect coordination.

Ceiling Fan Installation and Light Fixtures

A wobbly ceiling fan often has more to do with the ceiling box than the fan itself. Regular fixture boxes aren't made to support a spinning fan. The NEC requires a fan-rated box, so that's one of the first things we check. Our ceiling fan installation work also includes mounting, balancing, and wall controls. Need help with lighting? We repair and install light fixtures, including kitchen pendants and recessed lights.

Generac Standby Generators

The August 2020 derecho left parts of the metro without power for days. It still comes up on almost every generator consult we do. We size and install Generac whole-home standby generators, set the automatic transfer switch, and keep units ready with annual maintenance visits.

Level 2 EV Chargers

A Level 2 charger runs on a dedicated 240-volt circuit, usually 40 to 60 amps. We check your panel's spare capacity first. Then we pull the permit and handle the EV charger installation, which most Johnston garages finish in a single visit.

Hot Tubs, Spas, Saunas, and Pools

Water and power need careful planning. A hot tub needs a GFCI-protected circuit plus an emergency disconnect within sight of the tub and at least 5 feet from the water. We run the wiring for hot tub and spa installation, saunas, and pool equipment.

Outdoor Lighting, LED Retrofits, and Power to Sheds

Spring and summer bring plenty of outdoor electrical work. We install landscape lighting, replace exterior fixtures, and run power to sheds and detached garages, either underground or overhead. Indoors, LED retrofits are another popular upgrade.

2759 86th St Ste 110 Urbandale, IA 50322, USA

Services We Provide

Residential
Commercial

Frequently Asked Questions About Our Electrician: Johnston, IA

Yes, an emergency electrician in Johnston, IA can be dispatched for burning smells, a buzzing or hot panel, sparking outlets, or half the house losing power. Turn off the affected breaker if it's safe to reach, then call. Don't wait these out. The NFPA estimates electrical distribution and lighting equipment caused an average of 32,620 U.S. home fires a year from 2015 to 2019, with December among the peak months.
Our electrical safety inspection covers your panel, wiring, outlets, grounding, and load distribution. We look for outdated wiring, overloaded circuits, missing GFCI and AFCI protection, and code violations that could lead to fire or shock. You get a written report listing every issue and the repair we recommend. Homebuyers in Johnston, Altoona, and Carlisle book this before closing so they know what they're buying.
Breakers trip when they detect an overload, a short circuit, or a ground fault. If one keeps tripping, the usual suspects are too many appliances on a single circuit, a breaker that's wearing out, or a wiring fault further down the line. Our electricians trace it with diagnostic tools, then tell you whether the fix is a circuit repair, a dedicated circuit, or a panel upgrade. Resetting it over and over isn't a fix. It's a warning you're choosing to ignore.
Look at the main breaker first. If it reads 100 amps and you're planning an EV charger, heat pump, or finished basement, you'll likely need 200-amp service. Other red flags include no open breaker slots, double-tapped breakers, a panel cover that feels warm, or an older Federal Pacific Stab-Lok or Zinsco panel. We see those brands in Johnston homes built before the mid-1980s, and we recommend replacing them outright.
It means running a new cable from a wall switch to the ceiling, installing a fan-rated box, and patching only small access holes. In most ranch homes in Johnston, attic access over the bedrooms makes this a half-day job. Two-story homes with finished space above take longer, since we have to fish the wire between floors. Either way, you'll know the price before we cut anything.
We install Level 2 EV chargers for homeowners throughout the Des Moines metro, including Pleasant Hill, Norwalk, and Mitchellville. The job starts with a check of your panel's available capacity. From there, we pull the required permit, run a dedicated 240-volt circuit, and mount the charger where you park. If your panel needs an upgrade to support the added load, we handle that as part of the same project.
We do, either underground or overhead, to detached garages, workshops, and sheds. Buried runs follow NEC Table 300.5, which calls for 24 inches of cover on direct-burial cable and 18 inches for PVC conduit in most yards. We size the circuit for the equipment you'll actually run, whether that's a few lights, power tools, or a 240-volt outlet for a welder or table saw. Customers in Polk City and Bondurant often call us when finishing a backyard workshop.
Generator work is one of our busiest services. We size, install, and maintain Generac standby generators for homes throughout the metro. Installation includes connecting to your natural gas or propane supply, installing the automatic transfer switch, and testing the full system under load. Annual maintenance visits check the battery, the transfer switch, and a load test so the unit is ready the next time the grid goes down.
We convert existing fixtures to LED throughout the house, including recessed lighting, under-cabinet lighting, and exterior fixtures. LED retrofits use less energy and give off far less heat than incandescent and halogen bulbs. We also design new recessed lighting layouts for kitchens, living rooms, and home offices. Homeowners in Altoona and Newton often ask for whole-home LED conversions while they're updating older wiring.
Every electrician on our team holds a state license issued through the Iowa Department of Inspections, Appeals, and Licensing (DIAL). Iowa requires licensed electricians to complete 18 hours of continuing education every three years, six of them on the National Electrical Code. That matters when you're comparing quotes for a licensed electrician in the Des Moines metro. You can verify any contractor's license on the DIAL website before you sign anything.
Call at any hour, or schedule an appointment online. We'll confirm an arrival window, and your electrician will give you a flat-rate quote before any work begins. We serve Johnston, Des Moines, Urbandale, Ankeny, Grimes, West Des Moines, and communities across the metro, and every job is backed by the Neighborly Done Right Promise®.