Storm season here opens in March and runs hard through July. Mr. Electric of Wichita installs whole home surge protection in Andover at the panel, where a spike traveling down the service line arrives first. A panel-mounted device that helps protect your home’s electrical circuits from sudden voltage spikes. Your Andover electrician sizes the unit to your service and tests it before leaving.
How Whole Home Surge Protection Works in Andover Homes
A whole-home surge protector (or SPD) is wired directly into your main electrical panel. If voltage spikes above safe levels, it routes the extra juice straight to ground in nanoseconds, keeping your household wiring running safely at 120 volts. Under NEC Article 230.67, all residential services need a Type 1 or Type 2 SPD rated for at least 10 kA—a rule that hits both panel upgrades and brand-new construction. Andover adopted the 2024 National Electrical Code through the regional building code in May 2025, so these protectors are now a standard requirement across the area. Your Wichita electrician pulls the permit through the city building department before the panel cover comes off.
For a standard 200-amp panel, the whole installation takes around two hours. Once we shut down the main power and pull off the panel cover, we inspect the bus bars and lugs for any signs of heat damage. We mount the surge protector in a dedicated two-pole breaker slot, keeping the wiring leads as short as possible; longer wires increase the voltage pass-through during a surge. Every terminal is torqued down to exact manufacturer specifications rather than guesswork. After flipping the power back on and checking for a green status light, we'll show you how to spot a blown module. Whether your home sits on Evergy’s grid in Green Valley or gets power from Butler Electric Cooperative out past Andover Road, the process is identical.
Why Andover Homeowners Call Mr. Electric of Wichita
We’ve worked out of Wichita since November 2016, and our electricians average ten years in the trade. Every one of them holds a Metropolitan Area Building and Construction Department license, which is what the City of Andover requires before an electrical permit gets issued in your name.
You get the price before we start. We quote by the job, not the hour, so a surge protector install costs what the written estimate says it costs even if the panel fights us.
We include a full safety checkup with every visit. Pop the panel open, and we’ll check your breakers, grounding system, smoke detectors, and switches, then tell you what’s what without any sales pitch. If everything looks good, we say so. Every job backs up with the Neighborly Done Right Promise®: if it isn't right, we fix it. Plus, we keep our vans stocked so we can finish most surge installs on trip one.