Home Rewiring Charlotte, NC

Most of the homes we rewire in Charlotte were built with aluminum branch wiring or cloth-insulated copper that's simply worn out. Aluminum expands and contracts more than copper does under load, which loosens connections at outlets and switches over time. That's what causes the warm cover plates and the intermittent flickering homeowners describe on the phone before we ever get to the house. A whole-home rewire means pulling new copper conductors to every circuit, not just patching the ones acting up. We fish wire through existing walls where the framing allows, cutting into drywall only where there's no other path, and we patch what we open before we leave. Every job gets pulled to the current NC Electrical Code, which is based on the 2020 NEC with state amendments. That means AFCI and GFCI protection on the circuits that require it now, even if the home never had it originally. We pull the permit, schedule the Mecklenburg County inspection, and walk you through what the inspector will be checking so there are no surprises when they show up.

A rewire is only as good as the panel it lands on. If your home still runs on a 60- or 100-amp panel, or you're looking at one of the older Federal Pacific or Zinsco panels known for breakers that don't trip when they should, we'll replace it as part of the job rather than tying new circuits into hardware that's already a liability. Grounding gets the same attention. Older homes in Charlotte's Cotswold and Elizabeth neighborhoods sometimes have a grounding rod that's corroded, undersized, or missing entirely. We install or replace grounding rods to current code as part of every rewire, since a rewire with a weak ground defeats a lot of the safety work the new wiring is supposed to provide. We'll also bring up surge protection at this stage, not as an upsell tacked onto the invoice, but because a whole-home surge protector installed at the panel is the single easiest way to protect the new wiring, the new devices, and anything you plug in after the job is done. It's a short conversation, and you decide whether it makes sense for your home.

Replacing the wiring is only half the job. The receptacles, switches, and fixtures the old wiring connected to are usually the same age, and they show it. Cracked cover plates, loose switches that wobble when you flip them, outlets that only hold a plug loosely: these are signs the devices themselves need replacing, not just the wire behind them. A whole-home re-device swaps every receptacle and switch in the house as part of the rewire, so you're not left with 1960s hardware wired to a 2026 electrical system. We'll upgrade to tamper-resistant outlets where code requires them, add GFCI protection in kitchens, bathrooms, and garages, and install AFCI breakers on the circuits that need them under the current NC amendments to the NEC. If your fixtures are original to the house, we'll replace them with something rated for the circuit and matched to how the room is actually used, whether that's a simple swap or a full layout change while the walls are already open. This is also the easiest point in the project to add an EV charger circuit if you're planning one down the road. Running that dedicated line while walls are open costs a fraction of what it costs to add later, so it's worth the conversation even if you don't own the vehicle yet. We finish with a final walkthrough, testing every outlet and switch in the house before we consider the job done, not just the ones on the punch list.