Electrical Panel Upgrades St. Augustine Shores, FL

A licensed St. Augustine electrician from our crew inspects the panel first. Lights flickering when the AC kicks on or a breaker that won't stay reset are common early signs. A burnt smell by the panel box is more urgent: stop guessing and call. Either way, the panel can't carry the load your home actually draws. Many St. Augustine Shores homes built in the 1970s and 1980s still have 100-amp Federal Pacific or Zinsco panels. Both brands were pulled from production decades ago after widespread reports of breakers that fail to trip during an overload, and neither is a panel we repair. We replace them outright with a 150- or 200-amp panel sized for your actual circuit protection needs, enough for central air and an EV charger. A whole-house generator or a kitchen remodel with dedicated appliance circuits can push demand even higher.

Salt air corrosion is a real factor this close to the Matanzas River and the Intracoastal. Breaker lugs and bus bars pit faster in coastal St. Johns County than they would forty miles inland, so we check for corrosion at every service call, not just when a homeowner calls about a tripped breaker. Flood zone considerations matter too. Where FEMA maps put a home's panel below base flood elevation, we relocate or raise it during the upgrade. We also pull the St. Johns County permit before any work starts. GFCI replacement and AFCI breaker additions are usually bundled into the same visit, since the current National Electrical Code requires both in most rooms of a home during rewiring or a panel swap.

What St. Augustine Shores Homeowners Get When They Call Mr. Electric for an Electrical Panel Upgrade

Our St. Augustine Shores team averages 15 years of field experience, and every electrician on the job is licensed and insured under Florida law. We've worked on panels in the historic district and in newer construction out toward Palencia and World Golf Village, plus service calls in Anastasia Island and St. Augustine Beach. We also run out toward Butler Beach and Crescent Beach, and up the coast to Vilano Beach. Our service area reaches inland, covering Palm Valley and Ponte Vedra for the same panel and circuit work. That range means we've seen the specific wiring quirks each part of St. Johns County throws at a panel, from knob-and-tube remnants in older homes to capacity gaps in additions built without a permit. Ready to fix a panel that keeps tripping? Schedule an appointment with Mr. Electric of St. Augustine, and we'll get an electrician out to St. Augustine Shores.